CI
SCO 6509 核心交换机 WS-C6509-1300AC= Catalyst 6509 Chassis w/ 1300W AC Power Supply
冗余电源 WS-CAC-1300W/2 Catalyst 6000 Second 1300W AC Power Supply
交换机引擎 WS-X6K-S2-MSFC2 Catalyst 6500 Supervisor Engine-2, 2GE, plus MSFC-2 / PFC-2
冗余交换引擎 WS-X6K-S2-MSFC2/2 Catalyst 6500 Red. Sup2, 2GE, MSFC2 and PFC2 (In Chassis Only)
背板扩展模块 WS-C6500-SFM Catalyst 6500 Switch Fabric Module
电口模块 WS-X6316-GE-TX Catalyst 6000 16-port 1000TX GE Mod., RJ-45
光纤口模块 WS-X6408A-GBIC Catalyst 6000 8-port GE, Enhanced QoS (Req. GBICs)
1000BASE-ZX口(单模) WS-G5487 1000Base-ZX extended reach GBIC(singlemode)
1000BASE-LX/LH口(单模) WS-G5486 1000BASE-LX/LH long haul GBIC (singlemode or multimode)
Jac6509-sup
#!
#vtp
set vtp domain jac
set vtp passwd jac
set vlan 1 name default type ethernet mtu 1500 said 100001 state active
set vlan 2 name pub type ethernet mtu 1500 said 100002 state active
set vlan 3 name mgr type ethernet mtu 1500 said 100003 state active
set vlan 4 name tec type ethernet mtu 1500 said 100004 state active
set vlan 5 name test type ethernet mtu 1500 said 100005 state active
set vlan 1002 name fddi-default type fddi mtu 1500 said 101002 state active
set vlan 1004 name fddinet-default type fddinet mtu 1500 said 101004 state active stp
IEee
set vlan 1005 name trnet-default type trbrf mtu 1500 said 101005 state active stp ibm
set vlan 1003 name token-ring-default type trcrf mtu 1500 said 101003 state active mode srb aremaxhop 7 stemaxhop 7 backupcrf off
!
#ntp
set timezone PDT -7 0
!
#set boot command
set boot config-register 0x2
set boot system flash bootflash:cat6000-sup2k8.7-3-1.bin
!
# default port status is enable
!
!
#module 1 : 2-port 1000BaseX Supervisor
!
#module 2 : 2-port 1000BaseX Supervisor
!
#module 3 : 8-port 1000BaseX Ethernet
!
#module 4 : 16-port 1000BaseT Ethernet
set vlan 2 4/1-4
!
#module 5 : 0-port Switch Fabric Module
!
#module 6 empty
!
#module 7 empty
!
#module 8 empty
!
#module 9 empty
!
#module 15 : 1-port Multilayer Switch Feature Card
!
#module 16 : 1-port Multilayer Switch Feature Card
end
jac 6509-msfc
interface Vlan2
ip address 192.168.9.252 255.255.255.0
no ip redirects
standby ip 192.168.9.254
!
interface Vlan3
ip address 10.1.255.253 255.255.0.0
ip access-group mgr in
no ip redirects
standby ip 10.1.255.254
!
interface Vlan4
ip address 10.2.255.253 255.255.0.0
ip access-group tec in
no ip redirects
standby ip 10.2.255.254
!
ip classless
no ip http server
!
!
ip access-list extended mgr
permit ip 10.1.0.0 0.0.255.255 10.1.0.0 0.0.255.255
deny ip 10.1.0.0 0.0.255.255 10.0.0.0 0.255.255.255
permit ip 10.1.0.0 0.0.255.255 any
ip access-list extended tec
permit ip 10.2.0.0 0.0.255.255 10.2.0.0 0.0.255.255
deny ip 10.2.0.0 0.0.255.255 10.0.0.0 0.255.255.255
permit ip 10.2.0.0 0.0.255.255 any
!
!